Instrument Cluster (IC)

INSTRUMENT CLUSTER (IC)







Removal
1. If installing a new instrument cluster, upload the module configuration information to the scan tool using the programmable module installation (PMI) procedure.
2. Disconnect the battery.
3. Remove the instrument cluster (IC) finish panel.
4. Remove the 4 screws and position the instrument cluster (IC) away from the instrument panel.
- Disconnect the electrical connectors.

5. Disconnect the transmission range indicator and remove the instrument cluster (IC).

Installation
1. Position the instrument cluster (IC) in the instrument panel and connect the transmission range indicator.
2. Connect the electrical connector and install the 4 instrument cluster (IC) screws.
3. Install the instrument cluster (IC) finish panel.
4. Connect the battery.
5. If installing a new instrument cluster (IC), download the instrument cluster (IC) configuration information from the scan tool into the new instrument cluster (IC).

6. NOTE: If a new instrument cluster (IC) is installed, the instrument cluster (IC) and the powertrain control module (PCM) require a parameter reset to allow the instrument cluster (IC) and the PCM to recognize each other. Failure to carry out the parameter reset to the instrument cluster (IC) and the PCM may result in a no start condition on both passive anti-theft system (PATS) and non-PATS vehicles.

If installing a new instrument cluster (IC), carry out the parameter reset procedure.

7. If installing a new instrument cluster (IC), carry out the key programming.