Seat Track - Rear, Bucket
SEAT TRACK - REAR, BUCKETRemoval and Installation
LH and RH seat track rails
1. Insert an appropriate tool into the slot and release the detachable safety belt anchor from the seat.
2. Remove the seat.
- Pull the seat latch release handle, slide the seat to the right and disengage from the seat latch striker.
3. Position the seat forward on the seat track.
4. Remove the 4 nuts and seat pedestal.
- To install, tighten to 25 Nm (18 lb-ft).
- For installation, make sure the LH and RH seat track rails are aligned evenly.
5. Detach the linkage from the seat track release lever.
- Slide back the retainer spring and un-hook the linkage.
LH seat track rail
6. Remove the 3 screws and LH cushion side shield.
7. Remove the 2 lower recliner bolts.
- To install, tighten to 48 Nm (35 lb-ft).
8. Remove the 2 seat track-to-cushion frame bolts and LH seat track rail.
- To install, tighten to 25 Nm (18 lb-ft).
RH seat track rail
9. Remove the 3 screws and RH cushion side shield.
10. Remove the backrest pivot bolt.
- To install, tighten to 25 Nm (18 lb-ft).
11. Remove the 2 seat track-to-cushion frame bolts and RH seat track rail.
- To install, tighten to 25 Nm (18 lb-ft).
LH and RH seat track rails
12. To install, reverse the removal procedure.