Steps 41-78

Engine





Removal

41. Disengage the harness routing clips and position aside the battery feed wiring harness.





42. If equipped, disconnect the air temperature sensor electrical connector.





43. Disconnect the front impact severity sensor electrical connector.





44. Disconnect the horn electrical connector.





45. Disconnect the transmission fluid cooler hose retainers.





46. Remove the bolt and position the transmission fluid cooler aside.





47. NOTE: RH shown, LH similar.

Remove the pin-type retainers and the RH and LH air deflectors.





48. NOTE: RH shown, LH similar.

Remove the 4 bolts and the 2 upper radiator support plates.





49. NOTE: RH shown, LH similar.

Remove the 8 bolts and the upper radiator support.





50. Remove the bolt and disconnect the 2 headlamp wiring harness retainers.





51. Disconnect the 4 wiring harness retainers and position the wiring harness aside.





52. NOTE: LH shown, RH similar.

Remove the 12 bolts and the lower radiator support.





53. Disconnect the lower radiator coolant hose and position aside.





54. Remove the 3 bolts and the power steering pump.





55. Disconnect the generator electrical connections.

1. Remove the B+ terminal nut and disconnect the terminal.

2. Disconnect the S electrical connector.

3. Disconnect the ASI electrical connector.





56. Remove the 2 bolts and the generator.





57. Disconnect the quick connect coupling and remove the crankcase ventilation tube.





58. Disconnect the electrical connector.





59. Disconnect the engine wiring harness retainer and the 2 PCM electrical connectors.





60. Disconnect the 2 generator wiring harness retainers and position the wiring harness aside.





61. Disconnect the electrical connector, electrical connector retainer and remove the nut, ground strap and mounting bracket.





62. Remove the engine oil filler tube support strap bolt.





63. Remove the fluid level indicator and disconnect the attachments at the transmission fluid filler tube.

1. Remove the fluid level indicator.

2. Disconnect the rear heater hose hanger.





64. Disconnect the oil fill tube from the RH valve cover.





4.6L (2V) engine

65. Disconnect the coolant hose from the heater outlet tube and remove the heater outlet tube stud.





5.4L (2V) engine

66. Disconnect the Knock Sensor (KS) electrical connector and engine wiring harness retainers.





67. Disconnect the coolant hose from the heater outlet tube.





68. Remove the 2 heater outlet tube studs.





All engines

69. Remove the heater outlet tube.
- Discard the O-ring seals.





70. Remove the bolt and the ground strap and disconnect the RH HO2S electrical connector and retainer.





71. Disconnect the transmission wiring harness retainers from the engine wiring harness.





72. Disconnect the LH HO2S sensor electrical wiring harness retainer from the rear of the LH cylinder head.





73. Disconnect the transmission wiring harness retainer and position the transmission wiring harness aside.





74. Disconnect the LH HO2S sensor electrical connector and retainer.





75. Remove the 4 upper transmission-to-engine bolts and position the fuel tube support bracket aside.





76. Install the Engine Lifting Bracket.





77. Support the transmission with a jack.

78. Using a suitable floor crane, remove the engine assembly from the vehicle.