Headlamp: Service and Repair
Headlamp Assembly
Aerodynamic
Sealed Beam
Removal and Installation
NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.
Aerodynamic
1. Remove the 3 bolts and the headlamp assembly.
- Disconnect the electrical connectors.
Sealed beam
2. Remove the side lamp/front turn signal lamp. For additional information, refer to Side Lamp/Front Turn Signal Lamp Bulb Service and Repair.
3. Remove the 4 screws and the headlamp retaining ring.
4. Remove the headlamp assembly.
- Disconnect the electrical connector.
All headlamp types
5. To install, reverse the removal procedure.