Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor

















Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the splash shield.

3. Rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the A/C compressor pulley.





4. Disconnect and detach the Crankshaft Position (CKP) sensor electrical connector and position the wiring harness aside.

5. Detach the wiring harness from the bracket.





6. Disconnect the A/C compressor electrical connector.

7. NOTE: It is not necessary to remove the A/C compressor bolts.

Loosen the 3 bolts enough to slide the A/C compressor down 25.4 mm (1 in), allowing access for CKP sensor removal.

- To install, tighten to 25 Nm (18 lb-ft).

8. Remove the CKP sensor bolt and the CKP sensor. Inspect the O-ring seal for damage and replace if necessary.
- Lubricate the O-ring seal with clean engine oil prior to installation.

- To install, tighten to 10 Nm (89 lb-in).

9. To install, reverse the removal procedure.

10. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.