Ignition Lock Cylinder - Functional

Ignition Lock Cylinder - Functional









Removal and Installation

NOTE: When a new lock cylinder is installed, the door lock cylinder and ignition lock cylinder should be installed as a set. This eliminates carrying an extra key which will fit only one lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.

1. Insert the key into the ignition lock cylinder and turn it to the RUN position.

2. Using a suitable tool, press the ignition lock cylinder release pin and remove the ignition lock cylinder.





3. For vehicles equipped with Passive Anti-Theft System (PATS) , if a new lock cylinder with keys is replaced, the new PATS keys must be programmed. For additional information, refer to Key Programming Using Diagnostic Equipment in Antitheft and Alarm Systems. Using Diagnostic Equipment

4. To install, reverse the removal procedure.