Transmission Fluid Cooler Tubes - TorqShift

Transmission Fluid Cooler Tubes - TorqShift









Transmission Fluid Cooler Tubes - TorqShift(R)









Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Disconnect the battery ground cable.

3. If equipped, remove the pushpin retainers and the splash shield.





4. Remove the pushpin retainers and the lower air deflector.





5. Remove the transmission fluid cooler tubes from the transmission case.





6. Remove the secondary latch from the transmission fluid cooler hose.





7. Using the Transmission Cooler Line Disconnect Tool, disconnect the transmission fluid cooler hose.





8. Disconnect the fluid cooler hose from the radiator.





9. Remove the nut for the transmission cooler tubes and starter motor electrical harness front bracket, and move the bracket aside.





10. If equipped, remove the transmission cooler tubes from the bracket.





11. Remove the starter motor solenoid terminal cover.





12. Disconnect the starter motor electrical connections.





13. Disconnect the starter motor electrical harness pushpin and move the harness to the front of the vehicle.





14. Remove the transmission fluid cooler tubes from the vehicle.

Installation

1. Install the transmission fluid cooler tubes into the vehicle.

2. Reposition the starter motor electrical harness to the rear of the vehicle and connect the pushpin.





3. Connect the starter motor electrical connections.
- Tighten the ground cable to 20 Nm (177 lb-in).

- Tighten the battery cable to 12 Nm (106 lb-in).

- Tighten solenoid wire to 6 Nm (53 lb-in).





4. Install the starter motor solenoid terminal cover.





5. If equipped, install the transmission fluid cooler tubes into the bracket.





6. Install the transmission fluid cooler tubes bracket-to-engine stud nut.
- Tighten to 12 Nm (106 lb-in).





7. Connect the transmission fluid cooler hose.





8. Install the secondary latch onto the transmission fluid cooler hose.





9. Install the transmission fluid cooler hose onto the radiator fitting.





10. Install the transmission fluid cooler tube fittings.
- Tighten to 27 Nm (20 lb-ft).





11. Install the lower air deflector and the pushpin retainers.





12. If equipped, install the splash shield and the pushpin retainers.





13. Connect the battery ground cable.

14. NOTICE: The use of any transmission fluid other than the recommended transmission fluid can cause transmission damage.

Fill the transmission with the specified type and quantity of transmission fluid.

15. Check for leaks.