Autolock and Auto-Unlock Programming

Autolock and Auto-Unlock Programming

Programming the Autolock Feature Using the Door Lock Control Switch

NOTE: The autolock feature can be enabled or disabled independently of the auto-unlock feature.

NOTE: The autolock feature of the Smart Junction Box (SJB) can also be configured on or off with the scan tool. For additional information on module configuration, refer to Information Bus.

1. Close all the doors.

2. Confirm that the ignition switch is in the OFF position.

3. Turn the ignition switch from OFF to ON.

4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.

Press the door lock control switch unlock button 3 times.

5. Turn the ignition switch from ON to OFF.

6. Press the door lock control switch unlock button 3 times.

7. Turn the ignition switch from OFF to ON. The horn chirps once to indicate that programming mode is entered.

8. To enable/disable the autolock feature, press the unlock button on the door lock control switch then the lock button. The horn chirps once if the autolocks are disabled or twice (one short chirp followed by a honk) if the autolocks are enabled.

9. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.

Programming the Auto-Unlock Feature Using the Door Lock Control Switch

NOTE: The auto-unlock feature can be activated or deactivated independently of the autolock feature.

NOTE: The auto-unlock feature of the SJB can also be configured on or off with the scan tool. For additional information on module configuration, refer to Information Bus.

1. Close all the doors.

2. Confirm that the ignition switch is in the OFF position.

3. Turn the ignition switch from OFF to ON.

4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.

Press the door lock control switch unlock button 3 times.

5. Turn the ignition switch from ON to OFF.

6. Press the door lock control switch unlock button 3 times.

7. Turn the ignition switch from OFF to ON. The horn chirps once to indicate that programming mode is entered.

8. To enable/disable the auto-unlock feature, press the lock button on the door lock control switch then the unlock button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.

9. Turn the ignition key to the OFF position. The horn chirps once to signal that the programming is complete.