Wheel Speed Sensor Ring - Rear

Wheel Speed Sensor Ring - Rear













Removal

1. Remove the rear axle shaft.

2. NOTICE: Do not allow tools to come in contact with the machined surface of the axle shaft or damage to the axle shaft may occur.

Cut a groove in the wheel speed sensor ring approximately 3 mm (0.118 in) deep as shown.





3. Using a suitable driver, remove the wheel speed sensor ring from the axle shaft.





Installation

1. Using the Axle Bearing/Seal Plate and a press, install the wheel speed sensor ring.





2. Install the rear axle shaft.