Shifter A/T: Service and Repair

Selector Lever

Selector Lever









Removal and Installation

1. Disconnect the battery.

2. Remove the 2 screws and Data Link Connector (DLC).





3. Pull to release the retaining clips and remove the steering column opening lower finish panel.

4. If equipped with tilt column, position the steering wheel in the full DOWN position.

5. Remove the ignition switch lock cylinder.

1. Position the lock cylinder to RUN.

2. Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.





6. Remove the 3 screws and remove the lower steering column shroud.

7. Remove the upper steering column shroud.

8. Disconnect the Transmission Control Switch (TCS) connector.





9. NOTE: Install a new selector lever pin whenever it is removed.

Remove the selector lever.

1. Remove the selector lever pin.

2. Remove the selector lever.





10. To install, reverse the removal procedure.