120000 MI or 192000 KM
InspectVehicle
Recommended Multi-point Inspection
Universal Joint, Drive/Propeller Shaft
If equipped.
Tie Rod End
Inspect tie rod ends (lubricate if equipped with Zerk fittings)
Steering and Suspension
Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
Exhaust System
Inspect exhaust system and heat shields.
Drive/Propeller Shaft
If equipped.
Drive Belt
Inspect accessory drive belts
Cooling System
Every 15,000 miles (24,000 km), 600 hours of engine operation or as indicated by the instrument cluster message center
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system.
Ball Joint
If equipped.
Replace
Wheel Bearing
Replace front wheel bearing grease and grease seal if non-sealed bearings are used (2WD vehicles).
Positive Crankcase Ventilation Valve
Replace PCV valve on all light trucks over 6,000 lbs. Gross Vehicle Weight (GVW) (except 3V engines).
Oil Filter, Engine
Fuel Filter
Replace fuel filter (not required for Fusion, Milan, MKZ, Edge, MKX, Taurus X, Taurus, Focus, Sable, E-Series, Escape, Mariner, F-150, Flex, MKS, Expedition/Navigator (short wheel base only).
Fluid - A/T
Replace automatic transmission fluid on all vehicles equipped with the TorqShift transmission. Consult your dealer for your particular requirements.
Filters
Climate-controlled seat filter
Engine Oil
Change engine oil and filter.
Air Filter Element
Replace engine air filter (except Focus with PZEV engine).
Rotate
Tires
Rotate tires, inspect for wear, measure tread depth and inspect wheel ends for end play and noise. Vehicles with dual rear wheels should only rotate if unusual wear is noted. For vehicles with different front-to-rear tire pressures, the tire pressure must be adjusted and the tire pressure sensor training must be done.