120000 MI or 192000 KM

Inspect
    Vehicle
      Recommended Multi-point Inspection
    Universal Joint, Drive/Propeller Shaft
      If equipped.
    Tie Rod End
      Inspect tie rod ends (lubricate if equipped with Zerk fittings)
    Steering and Suspension
      Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
    Exhaust System
      Inspect exhaust system and heat shields.
    Drive/Propeller Shaft
      If equipped.
    Drive Belt
      Inspect accessory drive belts
    Brakes and Traction Control
      Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system.
    Ball Joint
      If equipped.
    Air Filter Restriction Sensor / Switch
      Inspect air filter restriction gauge. Replace filter as required or when air filter restriction gauge indicates, reset gauge.
Replace
    Wheel Bearing
      Replace front wheel bearing grease and grease seal if non-sealed bearings are used (2WD vehicles).
    Oil Filter, Engine
    Fuel Filter
      Replace engine and frame mounted fuel filters.
    Fluid Filter - A/T
      Replace automatic transmission fluid filter on all vehicles equipped with the TorqShift transmission.
    Fluid - A/T
      Replace automatic transmission fluid on all vehicles equipped with the TorqShift transmission. Consult your dealer for your particular requirements.
    Engine Oil
      Change engine oil and filter.
Rotate
    Tires
      Rotate tires, inspect for wear and measure for tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted).