150000 MI or 240000 KM

Inspect
    Vehicle
      Recommended Multi-point Inspection
    Universal Joint, Drive/Propeller Shaft
      If equipped.
    Tie Rod End
      Inspect tie rod ends (lubricate if equipped with Zerk fittings)
    Steering and Suspension
      Inspect steering linkage, ball joints, suspension, tie-rod ends, driveshaft and U-joints; lubricate if equipped with grease fittings.
    Fluid - A/T
      Inspect automatic transmission fluid level.
    Exhaust System
      Inspect exhaust system and heat shields.
    Drive/Propeller Shaft
      If equipped.
    Brakes and Traction Control
      Inspect brake pads, shoes, rotors, drums, brake lines and hoses and parking brake system.
    Ball Joint
      If equipped.
    Air Filter Restriction Sensor / Switch
      Inspect air filter restriction gauge. Replace filter as required or when air filter restriction gauge indicates, reset gauge.
Replace
    Wheel Bearing
      Replace wheel bearings (if non-sealed bearings)
    Oil Filter, Engine
    Fuel Filter
      Replace engine and frame mounted fuel filters.
    Fluid - Differential
      Replace rear wheel drive (RWD) axle fluid - DANA axles "NOT" using synthetic fluid only.
    Engine Oil
      Change engine oil and filter.
    Drive Belt
      Replace drive belt(s) if not replaced in the last 100,000 miles.
    Coolant
      Replace Engine Coolant
Rotate
    Tires
      Rotate tires, inspect for wear and measure for tread depth (vehicles with dual rear wheels should only rotate if unusual wear is noted).