Selector Lever Cable and Bracket - 4R70E, 4R75E

Selector Lever Cable and Bracket - 4R70E, 4R75E









Removal and Installation

NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the steering column shift tube bracket and the steering column bracket.

1. Remove the 2 screws and Data Link Connector (DLC).





2. Pull to release the retaining clips and remove the steering column opening lower finish panel.

3. Remove the 4 steering column-to-cross car beam nuts and lower the steering column.
- To install, tighten to 15 Nm (133 lb-in).





4. Disconnect the selector lever cable.

1. Disconnect the selector lever cable from the steering column shift tube lever.

2. Carefully lift the locking tab and disconnect the selector lever cable from the steering column bracket.





5. Push the rubber grommet and the selector lever cable through the bulkhead.

6. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

7. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the transmission manual control lever and the selector lever cable bracket.

Disconnect the selector lever cable at the manual control lever.





8. Remove the selector lever cable retaining clip and selector lever cable from the bracket.
- Discard the selector lever cable retaining clip.





9. Remove the selector lever cable bracket.
- Remove the selector lever cable bracket bolts.

- To install, tighten to 28 Nm (21 lb-ft).

- Remove the selector lever cable bracket.





10. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever cable into the selector lever cable bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket.

To install, reverse the removal procedure.

- Adjust the selector lever cable. For additional information, refer to Selector Lever Cable Adjustment Selector Lever Cable Adjustment.