Gearshift Lever

Gearshift Lever









Removal

1. Remove the gearshift lever knob and boot assembly.

2. Remove the floor console finish panel.

3. Remove the 2 gearshift cable clips.





4. Carefully disconnect the gearshift cables from the gearshift lever.

5. Remove the 4 gearshift lever nuts.

6. Remove the gearshift lever.

Installation

1. Position the gearshift lever.

2. Connect the gearshift cables to the gearshift lever.









3. NOTE: Make sure the clips are set completely within the cable adapter groove and fully seated.

Install the 2 gearshift cable clips.





4. Install the 4 gearshift lever nuts.
- Tighten to 25 Nm (18 lb-ft).

5. Adjust the gearshift cables. For additional information, refer to Manual Transmission/Transaxle &/or Clutch, M/T.

6. Install the floor console finish panel.

7. Install the gearshift lever knob and boot assembly.