Seat - Second Row, Bucket

Seat - Second Row, Bucket





NOTE: When installing any seat-to-floor bolts or floor studs, apply threadlock.











Removal and Installation

NOTE: LH seat shown, RH seat similar.

1. Remove the front seat-to-floor nut and bolt.

2. Fold the affected bucket seat up to the E-Z entry position.

3. Pull up to release and remove the floor riser trim cover.

4. Remove the safety belt buckle bolt and the safety belt buckle.

5. Remove the 3 seat-to-floor bolts.

6. Remove the bucket seat.

Installation

1. Position the seat in the vehicle.

2. Tighten the retainers in the following sequence.

1. Apply threadlock and tighten to 40 Nm (30 lb-ft).

2. Tighten to 40 Nm (30 lb-ft).

3. Apply threadlock and tighten to 40 Nm (30 lb-ft).

4. Apply threadlock and tighten the remaining 2 bolts in any sequence to 55 Nm (41 lb-ft).





3. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Position the safety belt buckle and install the bolt.

- Apply threadlock and tighten to 47 Nm (35 lb-ft).