Operation CHARM: Car repair manuals for everyone.

Pinpoint Test W: Poor Quality/Distorted/No Sound From All Speakers




Information and Entertainment System

Pinpoint Tests

Pinpoint Test W: Poor Quality/Distorted/No Sound From All Speakers

Refer to Wiring Diagram Set 130, Audio System/Navigation for schematic and connector information. Diagrams By Number

Normal Operation

When the ignition is in the START position, voltage is supplied to the Audio Control Module (ACM) through the start sense circuit. When the ACM receives this voltage, it mutes the speaker output to prevent popping in the speakers as a result of voltage spikes during engine cranking; however, if there is a short to voltage on this circuit, the ACM continuously mutes the audio output, resulting in no sound from all speakers.

This pinpoint test is intended to diagnose the following:

- Wiring, terminals or connectors
- ACM



PINPOINT TEST W: POOR QUALITY/DISTORTED/NO SOUND FROM ALL SPEAKERS

NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.

-------------------------------------------------
W1 CHECK THE START SENSE CIRCUIT FOR A SHORT TO VOLTAGE


- Ignition OFF.
- Disconnect: ACM C290a.
- Ignition ON.
- Measure the voltage between the ACM C290a-15, circuit CBP11 (BN), harness side and ground.




- Is any voltage present?

Yes
REPAIR the circuit. TEST the system for normal operation.

No
GO to W2.

-------------------------------------------------
W2 CHECK FOR CORRECT ACM OPERATION


- Ignition OFF.
- Disconnect all the ACM connectors.
- Check for:
- corrosion
- damaged pins
- pushed-out pins
- Connect the ACM connectors and make sure they seat correctly.
- Operate the system and determine if the concern is still present.
- Is the concern still present?

Yes
INSTALL a new ACM. REFER to Audio Control Module (ACM) Audio Control Module (ACM). TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.

-------------------------------------------------