Steering Column Multifunction Switch

Steering Column Multifunction Switch

NOTE: Steering wheel removed for clarity.











Removal and Installation

NOTICE: Do not remove the ignition lock cylinder and the ignition switch at the same time or damage to the column may result.

1. Remove the 2 screws and the steering column opening cover.

2. Remove the 3 screws and the upper and lower steering column shrouds.

3. Disconnect the multifunction switch electrical connector.

4. Remove the 2 multifunction switch screws and the multifunction switch.
- To install, tighten to 3 Nm (27 lb-in).

5. To install, reverse the removal procedure.