Spark Plugs

Spark Plugs









Removal and Installation

1. NOTICE: It is important to twist the spark plug wire boot while pulling upward to avoid possible damage to the spark plug wire.

NOTE: Spark plug wires must be connected to the correct spark plug. Refer to the Cylinder-to-Coil Terminal Relationship, Engine Ignition Engine Ignition in the Description and Operation.

With a twisting motion, use the Spark Plug Wire Remover to pull the spark plug wire from the spark plug.





2. NOTE: Use compressed air to remove any foreign material from the spark plug wells before removing the spark plugs.

Remove the spark plugs.

- To install, tighten to 17 Nm (150 lb-in).

3. Use a suitable spark plug gap tool to check and adjust the spark plug gap.

4. NOTE: Apply silicone dielectric compound to the inside of the spark plug wire boots.

To install, reverse the removal procedure.