Rear Suspension

Wheel Bearing and Wheel Hub













Removal and Installation

NOTICE: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

1. Remove the wheel knuckle. For additional information, refer to Wheel Knuckle Service and Repair.

2. Remove the 3 brake disc shield bolts.
- To install, tighten to 8 Nm (71 lb-in).

3. Using the Bearing Puller and a suitable press, remove the wheel hub.





4. Remove the snap ring.

5. Using a suitable press and adapters, remove the wheel bearing.

6. To install, reverse the removal procedure.

7. Install the wheel knuckle. For additional information, refer to Wheel Knuckle Service and Repair.