Tail Lamp: Service and Repair

Rear Lamp Assembly

NOTE: Styleside lamp shown, flareside similar.











Removal and Installation

1. Remove the 2 rear lamp assembly bolts.
- To install, tighten to 5 Nm (44 lb-in).

2. Firmly pull the rear lamp assembly rearward to disengage the metal studs from the grommets on the outboard side of the sheet metal.
- Disconnect the electrical connectors.

3. If necessary, rotate the bulb holder counterclockwise approximately one-eighth turn and remove it.
- Separate the bulb from the bulb holder.

4. To install, reverse the removal procedure.