Antenna - Satellite Radio

Antenna - Satellite Radio









Removal and Installation

NOTE: This procedure applies to both the stand-alone satellite radio antenna and the combination satellite radio/Global Positioning System (GPS) antenna.

1. Remove the RH A-pillar trim panel.

2. Remove the 3 screws, the RH sun visor retaining clip, and the RH sun visor.
- If equipped, disconnect the electrical connector.

3. Lower the front of the headliner enough to gain access to the satellite radio antenna electrical connector.

4. NOTE: Remove the satellite antenna and pigtail through the mounting opening in the roof panel.

Remove the satellite antenna.

- Disconnect the electrical connector.

- Compress the tabs and release the satellite antenna from the roof panel.

5. To install, reverse the removal procedure.