Exterior Mirror

Exterior Mirror

Removal and Installation

NOTE: Do not remove the exterior mirror assembly when repairing an individual part. Individual components can be installed without removing the exterior mirror.

NOTE: The power folding mirrors may need to be synchronized anytime the mirrors are folded or unfolded without using the exterior mirror control switch, or if a new power folding mirror is installed. For additional information, refer to Exterior Mirror Motor Synchronization - Power Folding Programming and Relearning.

1. Remove the front door trim panel.

2. Position aside the water shield to gain access to the electrical connector.
- Disconnect the electrical connector, if equipped.

3. Remove the 3 exterior mirror nuts.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the exterior mirror.

5. To install, reverse the removal procedure.
- If equipped with power folding mirrors, they must be synchronized. For additional information, refer to Exterior Mirror Motor Synchronization - Power Folding Programming and Relearning.