Operation CHARM: Car repair manuals for everyone.
Home >> Ford Truck >> 2010 >> F 250 2WD Super Duty V10-6.8L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Accessories and Optional Equipment >> Communications Control Module >> Service and Repair >> Removal and Replacement >> Telematics Module

Telematics Module




Telematics Module









Removal

1. Turn the ignition to OFF.

2. Lower the glove compartment completely.

3. Disconnect the telematics module electrical connector.

4. Remove the RH instrument panel side trim panel. For additional information, refer to Instrument Panel - Exploded View in Instrument Cluster / Carrier &/or Interior Moulding / Trim.

5. Remove the 2 screws and the telematics module.
- Remove the telematics module through the glove compartment opening.

Installation

1. Position the telematics module and install the 2 screws.

2. Install the RH instrument panel side trim panel. For additional information, refer to Instrument Panel - Exploded View in Instrument Cluster / Carrier &/or Interior Moulding / Trim.

3. Connect the telematics module electrical connector.

4. Close the glove compartment.

5. Initialize the telematics module.

1. Wait 5 minutes after the modem-antenna is installed.

2. Turn the ignition to RUN.

3. Wait 10 seconds.

4. Start the vehicle and run the engine for 30 seconds.

5. Turn the ignition to OFF.

pro multis · About Operation CHARM