Fog/Driving Lamp: Service and Repair

Fog Lamp









Removal and Installation

NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, Vehicle Jacking and Lifting.

2. Disconnect the fog lamp electrical connector.
- Separate the harness from the fog lamp bracket.

3. Remove the 3 bolts and the fog lamp.
- To install, tighten to 5 Nm (44 lb-in).

4. To install, reverse the removal procedure.
- If necessary, adjust the fog lamps. For additional information, refer to Front Fog Lamp Adjustment Adjustments.