Front End Body Panels

Fender

Removal and Installation

1. Remove the headlamps and turn signals.

2. Remove the 2 screws at the lower edge of the front fender securing the splash shield.
- To install, tighten to 9 Nm (80 lb-in).





3. Remove the running board, if equipped.

4. Remove the 2 lower front fender bolts.
- To install, tighten to 12 Nm (106 lb-in).





5. Remove the pushpin at the rear lower edge of the front fender.





6. Remove the 2 bolts securing the lower rear of the front fender.
- To install, tighten to 9 Nm (80 lb-in).





7. Open the door, then remove the fender retaining bolt.
- To install, tighten to 9 Nm (80 lb-in).





8. Remove the inner rear front fender bolt.
- To install, tighten to 9 Nm (80 lb-in).





9. Remove the 3 upper fender retaining bolts.
- To install, tighten to 9 Nm (80 lb-in).





10. NOTE: Transfer parts as necessary.

Remove the front fender.

11. To install, reverse the removal procedure.