Pinpoint Test V: The Air Bag Warning Indicator Is Never/Always On

Instrumentation, Message Center and Warning Chimes

Pinpoint Tests

Pinpoint Test V: The Air Bag Warning Indicator Is Never/Always On

Normal Operation

The Instrument Cluster (IC) receives the Supplemental Restraint System (SRS) status from the Restraints Control Module (RCM) over the High Speed Controller Area Network (HS-CAN) communication bus. If an SRS concern is detected, the RCM sets a DTC and sends a message to the IC to turn on the air bag warning indicator. If the SRS status message is missing or is deemed invalid for more than 5 seconds, the IC sets DTC U0151 and defaults the air bag warning indicator on.

This pinpoint test is intended to diagnose the following:

- RCM
- IC



PINPOINT TEST V: THE AIR BAG WARNING INDICATOR IS NEVER/ALWAYS ON

-------------------------------------------------
V1 CARRY OUT THE IC RESTRAINTS OUTPUT CONTROL ACTIVE COMMAND USING THE SCAN TOOL


- Ignition ON.
- Enter the following diagnostic mode on the scan tool: IC DataLogger .
- Select the IC all warning indicators (ALL_LAMP) active command. Command all the warning indicators on and off. Observe the air bag warning indicator.
- Does the air bag warning indicator illuminate when commanded on and turn off when commanded off?

Yes
GO to V2.

No
INSTALL a new IC. REFER to Instrument Cluster (IC) Instrument Cluster (IC). TEST the system for normal operation.

-------------------------------------------------
V2 RETRIEVE THE RECORDED DTCs FROM THE RCM SELF-TEST


- Check for recorded RCM DTCs from the self-test.
- Are any DTCs recorded?

Yes
REFER to Restraint Systems.

No
GO to V3.

-------------------------------------------------
V3 RETRIEVE THE RECORDED DTCs FROM THE IC SELF-TEST


- Check for recorded IC DTCs from the self-test.
- Are any DTCs recorded?

Yes
For DTC U0151, GO to Pinpoint Test BI. Pinpoint Tests BI: DTC U0151

For DTC U2472, GO to Pinpoint Test BC. Pinpoint Tests BC: DTC B1555, B2A20 Or U2472

For all other DTCs, REFER to DTC Charts. Instrumentation, Message Center and Warning Chimes

No
INSTALL a new RCM. REFER to Restraint Systems. TEST the system for normal operation.

-------------------------------------------------