Rear Door: Service and Repair

Door - Rear, 4-Door









Removal and Installation

1. Disconnect the electrical connector at the door.

2. With a wax pencil, mark the position of each hinge.

3. Remove the 2 lower hinge-to-door bolts.
- To install, tighten to 30 Nm (22 lb-ft).





4. NOTICE: To avoid damaging the door, this step requires an assistant.

Remove the 2 upper hinge-to-door bolts and remove the door.

- To install, tighten to 30 Nm (22 lb-ft).





5. NOTICE: To minimize the possibility of cross threading, hand start all fasteners during the installation.

To install, reverse the removal procedure.

- Check for correct door alignment. For additional information, refer to Door Alignment - Rear, 4-Door Adjustments.