Exterior Mirror Glass

Exterior Mirror Glass

Removal

NOTE: LH shown, RH similar.

1. Position the exterior mirror glass to the full inboard position and locate the notch at the bottom of the exterior mirror glass.





2. Release the exterior mirror glass.
- Insert a long flat-blade screwdriver into the notch.

- Gently turn the screwdriver until the 2 outboard glass backing plate hooks are released from the exterior mirror motor.





3. Remove the exterior mirror glass.
- Using your fingers, carefully release the 2 inboard glass backing plate hooks from the exterior mirror motor.

- If equipped, disconnect the electrical connectors from the exterior mirror glass.

Installation

1. Position the exterior mirror motor to the center position.

2. If equipped, connect the electrical connectors to the exterior mirror glass.

3. Position the exterior mirror glass onto the exterior mirror motor.

4. WARNING: Place a shop towel between the hands and the exterior mirror glass for protection in case of glass breakage during mirror service. Failure to follow this instruction may result in serious personal injury.

NOTE: Make sure the exterior mirror damper springs are located inboard of the damper spring tracks. Failure to do this will restrict exterior mirror glass movement.

Place a hand against the back of the exterior mirror housing and a hand flat against the exterior mirror glass. Press the exterior mirror glass until it is fully seated.

5. Operate the exterior mirror and check for correct exterior mirror movement. If the exterior mirror glass movement is restricted, refer to Exterior Mirror Damper Spring Alignment Adjustments.