Condenser to Evaporator Line

Condenser to Evaporator Line













Removal and Installation

1. Recover the refrigerant.

2. Disconnect the evaporator inlet fitting.
- Discard the O-ring seals.

3. Remove the condenser outlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.

- To install, tighten to 8 Nm (71 lb-in).

4. To install, reverse the removal procedure.
- Install new O-ring seals.

- Lubricate the refrigerant system with the correct amount of clean PAG oil.

5. Evacuate, leak test and charge the refrigerant system.