Catalyst Monitor Sensor

Catalyst Monitor Sensor









Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the Catalyst Monitor Sensor (CMS) electrical connector.

3. NOTE: If necessary, lubricate the CMS with lock lubricant to assist in removal.

Using the Exhaust Gas Oxygen Sensor Socket, remove the CMS.





Installation

1. Apply a light coat of nickel anti-seize lubricant to the threads of the CMS.

2. Using the Exhaust Gas Oxygen Sensor Socket, install the CMS.
- Calculate the correct torque wrench setting for the following torque.

- Using the Exhaust Gas Oxygen Sensor Socket, tighten to 48 Nm (35 lb-ft).





3. Connect the CMS electrical connector.