Reverse Brake Drum

Reverse Brake Drum













Disassembly

1. NOTE: The installation of new low/reverse One-Way Clutch (OWC) and rollers can now be completed. The following procedure only needs to be carried out if there is damage to the low/reverse OWC and roller bearing.

Inspect the reverse brake drum for damage.

1. Inspect the low/reverse OWC.

2. Inspect the roller bearing.

3. Inspect the reverse brake drum.





2. With the reverse clutch drum supported, use a flat drift punch to tap the OWC and the roller bearing out of the drum.





3. Inspect the low/reverse OWC inner race and roller bearing inner race for scoring and nicks. If damage is indicated, the reverse clutch drum will need to be installed new as an assembly.





Assembly

1. Install the roller bearing with the lip facing up toward the low/reverse OWC.





2. Install the Reverse Drum/One-Way Clutch Sleeve.





3. Install the low/reverse OWC with the tabs facing down toward the roller bearing.





4. Using the Reverse Drum/One-Way Clutch Sleeve and the Reverse Drum/One-Way Clutch Installer, install the OWC by pressing down on the tool to seat the bearing.





5. Inspect the reverse clutch drum to see if the low/reverse OWC is seated correctly.