Inspection and Verification

Driveline System

Inspection and Verification

1. Verify the customer concern.

2. Visually inspect for obvious signs of mechanical damage.

Visual Inspection Chart





3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.

4. If the cause is not visually evident, verify the symptom and GO to Symptom Chart. Symptom Chart - Driveline


Driveshaft Center U-Joint and CV Joint Inspection

With the vehicle in NEUTRAL, position it on a hoist. Refer to Vehicle Jacking and Lifting. Rotate the driveshaft by hand. Check for rough operation or seizure of the U-joints or CV joints. Install a new U-joint or driveshaft if it shows signs of seizure, excessive wear or incorrect seating. Refer to Drive/Propeller Shafts, Bearings and Joints.