Transmission Support Crossmember

Transmission Support Crossmember

Removal and Installation

1. Secure a suitable transmission jack to the transmission.





2. Disconnect the wiring harness from the crossmember, if equipped.

3. Remove the transmission mount insulator nuts.
- To install, tighten to 94 Nm (69 lb-ft).





4. Remove the heat shield-to-crossmember bolts.





5. Remove the RH crossmember nuts.
- To install, tighten to 81 Nm (60 lb-ft).





6. Remove the LH crossmember nuts.
- To install, tighten to 81 Nm (60 lb-ft).





7. Remove the LH crossmember bolt.





8. Remove the RH crossmember bolt and transmission support crossmember.





9. To install, reverse the removal procedure.