Brake Disc - Single Rear Wheel (SRW)

Brake Disc - Single Rear Wheel (SRW)

Removal and Installation

1. Remove the wheel and tire. For additional information, refer to Wheels and Tires Removal and Replacement.

2. NOTICE: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.

- Support the caliper and anchor plate assembly using mechanic's wire.

- To install, tighten the bolts to 225 Nm (166 lb-ft).

3. Index-mark the brake disc.





4. Remove the brake disc.

5. To install, reverse the removal procedure.