Accelerator Pedal: Service and Repair

Accelerator Pedal

4.6L and 5.4L Engines









6.8L Engine









Removal and Installation

All vehicles

1. NOTE: To prevent setting DTCs, make sure the ignition switch is in the OFF position prior to disconnecting the accelerator pedal electrical connectors.

NOTE: If equipped, the red clip must be pulled out before disconnecting the electrical connector.

Disconnect the Accelerator Pedal Position (APP) sensor electrical connector.

4.6L and 5.4L engines

2. Remove the 2 bolts and the accelerator pedal.
- To install, tighten to 25 Nm (18 lb-ft).

6.8L engine

3. Remove the 2 bolts and slide the accelerator pedal and position sensor assembly up and off the anchor bolt.
- To install, tighten to 25 Nm (18 lb-ft).

All vehicles

4. To install, reverse the removal procedure.