Seat Backrest Cover - Rear, Bench

Seat Backrest Cover - Rear, Bench

Removal and Installation

NOTE: For parts identification and locations, refer to Seat - Exploded View, Rear, Bench Seat - Exploded View, Rear, Bench.

1. NOTE: RH shown, LH similar.

If equipped, insert an appropriate tool and release the detachable safety belt anchor(s) from the seat.





2. NOTE: The seat mounting latches are serviced as part of the bench seat risers. If either seat mounting latch is damaged and cannot be released, remove the seat latch striker with the seat attached. For additional information, refer to Seat Latch Striker - Rear, Bench Seat Latch Striker - Rear, Bench.

Pull the 2 seat latch release straps and remove the rear seat.

3. Remove the 10 bolts and 2 risers from the seat cushion frame.
- To install, tighten to 51 Nm (38 lb-ft).

4. If equipped, remove the bolt and detachable safety belt anchor.
- To install, tighten to 60 Nm (44 lb-ft).

5. Release all the backrest cover rear J-clips and remove the inner cardboard panel from the backrest.

6. Release the cushion cover rear J-clips and access the safety belt retractor anchor bolt.

7. Remove the center safety belt anchor bolt(s) and route the safety belt(s) through the seat cushion.
- To install, tighten to 75 Nm (55 lb-ft).

8. Remove the 2 screws and safety belt guide cover.
- If 4-passenger bench seat, remove both safety belt covers.

9. Remove the safety belt retractor cover.
- If 4-passenger bench seat, remove both safety belt retractor covers.

10. If equipped, remove the armrest. For additional information, refer to Seat Armrest - Rear, Bench Seat Armrest - Rear, Bench.

11. NOTICE: Use care not to tear the foam pad when releasing the backrest cover retainers.

Remove the backrest cover.

- Release the inner J-clips and invert the backrest cover up the backrest to the row of retainers.

- Separate the retainers and continue inverting the backrest cover.

- Route out the safety belt(s) and remove the backrest cover.

12. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

To install, reverse the removal procedure.