Inspection and Verification
Air Bag and Safety Belt Pretensioner Supplemental Restraint System (SRS)
Inspection and Verification
1. Verify the customer concern by checking the air bag warning indicator in the IPC module. Refer to Prove Out the System.
2. Visually inspect for obvious signs of mechanical or electrical damage. Do not disconnect electrical connectors until directed to do so within the pinpoint test.
Visual Inspection Chart
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
4. NOTE: Make sure to use the latest scan tool software release.
If the cause is not visually evident, connect the scan tool to the DLC.
5. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
If the scan tool does not communicate with the VCM:
- check the VCM connection to the vehicle.
- check the scan tool connection to the VCM.
- refer to Module Communications Network Testing and Inspection, No Power To The Scan Tool, to diagnose no power to the scan tool.
6. If the scan tool does not communicate with the vehicle:
- verify the ignition is in the ON position.
- verify the scan tool operation with a known good vehicle.
- refer to Module Communications Network Testing and Inspection to diagnose no response from the PCM.
7. Carry out the network test.
- If the scan tool responds with no communication for one or more modules, refer to Module Communications Network Testing and Inspection.
- If the network test passes, retrieve and record on-demand and Continuous Memory Diagnostic Trouble Codes (CMDTCs) from the RCM.
8. If the DTCs retrieved are related to the concern, go to the Restraints Control Module (RCM) DTC Chart Diagnostic Trouble Code Tests and Associated Procedures. For all other DTCs, refer to Multifunction Electronic Modules Testing and Inspection.
9. If no DTCs related to the concern are retrieved, GO to Symptom Chart. Symptom Related Diagnostic Procedures