Pinpoint Test A: The Brake Shift Interlock System Does Not Release/Lock Correctly

External Controls

Pinpoint Tests

PINPOINT TEST A: THE BRAKE SHIFT INTERLOCK SYSTEM DOES NOT RELEASE/LOCK CORRECTLY

NOTE: Perform a thorough inspection of the selector lever cable before proceeding with this pinpoint test.

-------------------------------------------------
A1 TEST THE BRAKE LIGHTS


- Apply the brake pedal and view the brake lights.
- Do the brake lights illuminate?

Yes
GO to A2.

No
Go to Exterior Lighting Testing and Inspection.

-------------------------------------------------
A2 TEST CIRCUIT CCB08 (VT/WH) FOR AN OPEN


- Disconnect: Brake Shift Interlock Actuator (BSIA) C2127 .
- Check to make sure the selector lever harness C2127 is fully seated, the terminals are fully engaged in the connector and are in good condition before proceeding.
- Measure the voltage from C2127-3, circuit CCB08 (VT/WH), harness side and ground while applying the Brake Pedal Position (BPP) switch.




- Is the voltage greater than 10 volts when applied?

Yes
GO to A3.

No
REPAIR circuit CCB08 (VT/WH) for an open. TEST the system for normal operation.

-------------------------------------------------
A3 TEST CIRCUIT GD114 (BK/BU) FOR AN OPEN


- Measure the voltage between BSIA C2127-1 and C2127-3 while applying the BPP switch.




- Is the voltage greater than 10 volts when applied?

Yes
INSTALL a new BSIA. TEST the system for normal operation.

No
REPAIR circuit GD114 (BK/BU) for an open. TEST the system for normal operation.

-------------------------------------------------