Operation CHARM: Car repair manuals for everyone.

Pinpoint Test AD: DTC U3003:16 (Front Controls Interface Module (FCIM) )




Information and Entertainment System

Pinpoint Test AD: DTC U3003:16 (Front Controls Interface Module (FCIM))

Normal Operation

- DTC U3003:16 (Battery Voltage: Circuit Voltage Below Threshold)- set by the Front Controls Interface Module (FCIM) when the supply voltage falls below 10 volts for at least 10 seconds during normal operation.

This pinpoint test is intended to diagnose the following:

- Wiring, terminals or connectors

- High circuit resistance

- FCIM (Front Controls Interface Module)

PINPOINT TEST AD : DTC U3003:16 (FCIM (Front Controls Interface Module))

NOTE: Failure to disconnect the battery when instructed will result in false resistance readings.

AD1 RECHECK THE FCIM (Front Controls Interface Module) DTCs

- Ignition ON.

- Clear the FCIM (Front Controls Interface Module) DTCs.

- Wait at least 15 seconds.

- Repeat the FCIM (Front Controls Interface Module) self-test.

Is DTC U3003:16 still present?

Yes
GO to AD2.

No
The system is operating correctly at this time. The DTC may have been set due to a previous low battery voltage condition.

AD2 CHECK FOR CHARGING SYSTEM DTCs IN THE PCM

- Retrieve the continuous DTCs from all modules.

Is DTC P0620, P0622, P0625 or P065B set in the PCM?

Yes
REFER to Charging System.

No
GO to AD3.

AD3 CHECK THE BATTERY CONDITION AND STATE OF CHARGE

- Check the battery condition and verify that the battery is fully charged.

Is the battery OK and fully charged?

Yes
GO to AD4.

No
REFER to Battery.

AD4 CHECK THE FCIM (Front Controls Interface Module) VOLTAGE SUPPLY

- Ignition OFF.

- Measure and record the voltage at the battery.

- Disconnect: FCIM (Front Controls Interface Module) C2402.

- Ignition ON.

- Measure the voltage between the FCIM (Front Controls Interface Module) C2402-1, circuit SBP14 (BN/RD), harness side and ground.





Is the voltage at the FCIM (Front Controls Interface Module) within 0.2 volt of the recorded battery voltage?

Yes
GO to AD5.

No
REPAIR the circuit for high resistance. CLEAR the DTCs. REPEAT the self-test.

AD5 CHECK THE FCIM (Front Controls Interface Module) GROUND CIRCUIT

- Ignition OFF.

- Disconnect: Negative Battery Cable.

- Measure the resistance between the FCIM (Front Controls Interface Module) C2402-2, circuit GD115 (BK/GY), harness side and ground.





Is the resistance less than 5 ohms?

Yes
GO to AD6.

No
REPAIR the circuit for high resistance. CLEAR the DTCs. REPEAT the self-test.

AD6 CHECK FOR CORRECT FCIM (Front Controls Interface Module) OPERATION

- Ignition OFF.

- Connect: Negative Battery Cable.

- Disconnect the FCIM (Front Controls Interface Module) connector.

- Check for:
- corrosion

- damaged pins

- pushed-out pins


- Connect the FCIM (Front Controls Interface Module) connector and make sure it seats correctly.

- Operate the system and determine if the concern is still present.

Is the concern still present?

Yes
INSTALL a new FCIM (Front Controls Interface Module). REFER to Front Controls Interface Module (FCIM) . TEST the system for normal operation.

No
The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.