30000 MI or 48000 KM
InspectVehicle
Multi-point Inspection
Steering and Suspension
Inspect steering and suspension ball joints and tie rods. Lubricate if equipped with grease fittings. If using Special Operating Conditions: D. Inspect steering and suspension ball joints and tie rods. Lubricate if equipped with grease fittings. If using Special Operating Conditions: O.
Fluid - A/T
Inspect automatic transmission fluid level.
Exhaust System
Exhaust Tips: Inspect functional holes in each leg of the twin tip and the holes under the shield just inboard of the right rear tire to make sure they are kept clean/clear of debris or foreign materials. If using Special Operating Conditions: O. Inspect exhaust system and heat shields.
Drive Axles, Bearings and Joints
Inspect front axle and U-joints. Lubricate if equipped with grease fittings.
Cooling System
Inspect engine and secondary coolant level and hoses.
Coolant
Inspect concentration (freeze-point protection) and additive (corrosion inhibitor) strength. Add engine coolant additive if required. If using Special Operating Conditions: I, L, H, T.
Brakes and Traction Control
Inspect brake pads, shoes, rotors, drums, brake linings, hoses and parking brake.
Air Cleaner Restriction Indicator
Inspect air filter restriction gauge. Replace filter if necessary.
Replace
Fuel Filter
Replace engine and frame mounted fuel filters. If using Special Operating Conditions: I, L, H, A, T, O, D, B.
Engine Oil
Change engine oil and filter as indicated by the information display and perform services listed in the scheduled maintenance chart. If using Special Operating Conditions: I, L, H, A, T, B, U. Change engine oil and filter. Change engine oil and filter. Reset your Intelligent Oil-Life Monitor after each engine oil and filter change. If using Special Operating Conditions: U.
Air Filter Element
Replace air inlet foam filter. If using Special Operating Conditions: O, D
Service or Charge
Diesel Emissions Fluid
Refill diesel exhaust fluid tank.
Rotate
Tires
Rotate tires, inspect tire wear and measure tread depth. Vehicles equipped with dual rear wheels should rotate the front wheels when specified; rear wheels only if unusual wear is noted.