Safety Belt Without Anchor Plate Thread Damage

The lap/shoulder safety belts are factory-installed in their proper locations. If the belts are removed for any reason, they should be installed using proper service procedures. The 7/16 x 20 Torx(r) head anchor bolts must be hand-started and then tightened to 30-40 Nm (22-30 lb-ft).

1. Remove the damaged bolt from the anchor reinforcement and discard.

Parts Replacement Chart:

2. Install a new bolt and hand-tighten. Tighten to 30-40 Nm (22-30 lb-ft).