Safety Belt With Anchor Plate Thread Damage

Parts Replacement Chart

Safety Belt With Anchor Plate Thread Damage
1. Remove the broken or stripped bolt and discard.
2. Drill out the internal threads in the safety belt anchor plate with a 27/64-inch drill.
3. Rethread the anchor plate with a 1/2-13 tap (safety belt).
4. Blow out the chips.
5. Install the attachment parts in the applicable sequence shown in Removal and Installation. Tighten the replacement bolt to 30-40 N.m (23-29 lb-ft).Original parts are to be replaced with the service parts indicated in the safety belt parts replacement chart.