Transmission Position Sensor/Switch: Service and Repair

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the engine air cleaner.
3. Disconnect the Transmission Range (TR) sensor electrical connector.
4. Remove the TR sensor bolts.
5. Remove the TR sensor.

INSTALLATION
1. Install the TR sensor.
2. Adjust the TR sensor. Refer to Adjustments.
3. Tighten the TR sensor bolts to 8-10 Nm (71-88 lb in).
4. Connect the TR sensor electrical connector.
5. Install the engine air cleaner.
6. Connect the battery ground cable.