New Generation Star Tester Useage

New Generation Star Tester Hookup and Vehicle Selection

NOTE: Before any diagnostics can be performed on the communication system, the New Generation Star Tester 007-00500 must be used.

1. Turn vehicle's ignition switch to OFF position.
2. Select the appropriate program card for the vehicle.
3. With the New Generation Star Tester control unit facing away from you, insert the program card into the slot on the back. If you insert the card incorrectly, New Generation Star Tester will not work.
4. Plug the New Generation Star Tester data link connector (DLC) cable to the vehicle DLC port (OBDII Connector).
5. Turn ignition switch to RUN position.
6. Plug the power cable into the vehicle's cigar lighter or into the battery hookup adapter if using the alternative hookup. New Generation Star Tester will perform an initialization, which checks that the New Generation Star Tester memory verifies the vehicle interface module (VIM) matches the program card software. If the screen displays an error message, refer to Appendix C New Generation Star Tester Operator Handbook, System Messages.
7. Menu item "Vehicle and Engine Selection" is highlighted. Press trigger to select.
8. Rotate dial to menu item "Select New Vehicle Model and Year" - press trigger.
9. Select year, Vehicle, and appropriate engine by rotating dial to highlight selection, then press trigger to select. (If the selected vehicle is not displayed on first row, then repeat steps 8 and 9. Otherwise, rotate dial to Selected Vehicle top row and press trigger.)