Front

1. Remove air inlet tube, then remove stabilizer bar retaining bracket bolts and brackets.
2. Remove serpentine drive belt, then raise and support vehicle.
3. Remove front tire and wheel assemblies, then remove crankshaft vibration damper.
4. Remove cotter pins and castellated nuts at rod ends.
5. Separate tie rod ends from spindles using tie rod end removal tool 3290-D or equivalent.
6. Remove transmission oil cooler line bracket.
7. Remove stabilizer bar link from stabilizer bar using joint separator D88L-3006-A or equivalent.
8. Remove stabilizer bar from right side of vehicles.
9. Remove stabilizer bar bushings from stabilizer bar.
10. Reverse procedure to install.