Procedures

REMOVAL

WARNING:
^ TO AVOID ACCIDENTAL DEPLOYMENT, THE AIR BAG CONTROL MODULE BACKUP POWER SUPPLY MUST BE DEPLETED. WAIT AT LEAST ONE MINUTE AFTER DISCONNECTING THE BATTERY GROUND CABLE(S) BEFORE COMMENCING ANY REPAIR OR ADJUSTMENT TO THE SUPPLEMENT RESTRAINT SYSTEM (SRS), OR ANY COMPONENT(S) ADJACENT TO THE SRS SENSORS. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY.
^ TO MINIMIZE THE POSSIBILITY OF PREMATURE DEPLOYMENT, DO NOT USE RADIO KEY CODE SAVERS WHEN WORKING ON THE SUPPLEMENTAL RESTRAINT SYSTEM. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.
^ NEVER PROBE THE ELECTRICAL CONNECTORS OF AIR BAG MODULES OR ANY OTHER SUPPLEMENTAL RESTRAINT SYSTEM COMPONENT. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.

1. Disconnect the battery ground cable.
2. Raise and support the vehicle.







3. Remove the radiator right-hand support bracket retaining bolts and lower the right-hand side of the radiator.
4. Lower the vehicle.







5. Remove the radiator air deflector.







6. Detach the crash sensor from the radiator grille opening panel.







7. Remove the crash sensor.
^ Disconnect the crash sensor electrical connector.

INSTALLATION

All vehicles

WARNING:
^ MAKE SURE THE CRASH SENSOR LOCATING TANGS ARE CORRECTLY LOCATED IN THE RADIATOR GRILLE OPENING PANEL. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.
^ NEVER PROBE THE ELECTRICAL CONNECTORS OF AIR BAG MODULES OR ANY OTHER SUPPLEMENTAL RESTRAINT SYSTEM COMPONENT. FAILURE TO FOLLOW THIS INSTRUCTION MAY RESULT IN PERSONAL INJURY.

1. To install, reverse the removal procedure.

Vehicles with front and rear power windows

2. Initialize the door window motors.