Selector Plate
Selector PlateDisassembly
1. Remove the reversing light switch.
2. Remove the reversing light actuating pin.
- Discard the bolt.
3. Remove the gearshift lever and the cover of the internal selector mechanism.
4. NOTE: The bolt is inserted with locking compound.
Loosen the bolt and remove the gearshift and selector lever shaft guide.
- Heat the bolt to approximately 60 to 80°C using a hot air blower and remove it.
5. Remove the selector block and the spring, remove the shift lever.
6. Remove the selector gate and selector shaft from the selector mechanism housing.
1. Remove the bolt.
2. Remove the selector gate with the selector shaft.
- Remove the spring.
7. Remove the selector shaft.
1. Pull out the selector gate form the selector shaft.
2. Remove the selector finger and bracket.
8. Remove the snap-ring and washer from the selector shaft.
9. Remove the gearshift lever shaft.
10. Remove the oil seals.
11. Drive both the needle roller bearings of the gearshift lever shaft inwards using a suitable socket and remove them.
Assembly
1. Drive in the upper needle roller bearing of the gearshift lever shaft using a suitable socket.
2. Install the oil seals.
- Coat the oil seal with sealer.
1. Drive in the oil seal as far as the stop using a suitable socket.
NOTE: Installation depth.
2. Install the oil seal.
3. Install the lower needle roller bearing of the gearshift lever shaft together with the gearshift lever shaft.
4. Set the end float on the gearshift lever shaft to 0.3 + 0.1 mm by tapping lightly.
5. Slide the snap-ring and washer onto the selector shaft.
6. Assemble the selector finger and bracket, insert it in the selector gate.
1. Selector finger
2. Selector finger bracket
7. NOTE: Install a new bolt and tighten it lightly.
Install the selector shaft and bolt.
1. Push the selector gate to the selector shaft.
2. Install the bolt and tighten it lightly.
8. Install the selector gate and selector shaft to the selector mechanism housing and tighten the bolt.
- Check the selector shaft freeplay.
9. NOTE: Install a new reversing light actuating pin.
Install the selector block and the spring.
- Install a new reversing light actuating pin.
10. Install the selector lever shaft and the ball bearing.
11. Install the cover of the inner gearshift mechanism using sealer.
12. Install the reversing light switch.