Pressure

Brake System Bleeding-Pressure

WARNING: Use of any other than approved DOT 3 or DOT 4 brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.

WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.

CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

CAUTION: Do not allow the master cylinder to run dry during the bleeding operation. Keep the master cylinder reservoir filled with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.

1. Clean all dirt from and remove the brake master cylinder filler cap. Fill the brake master cylinder reservoir with the specified brake fluid.

2. NOTE: Master cylinder pressure bleeder adapter tools are available from various manufacturers of pressure bleeding equipment. Follow the instructions of the manufacturer when installing the adapter.

Install the bleeder adapter to the brake master cylinder reservoir, and attach the bleeder tank hose to the fitting on the adapter.

3. NOTE: Bleed the longest line first. Make sure the bleeder tank contains enough specified brake fluid to complete the bleeding operation.

Remove the bleeder screw cap and place a box end wrench on the RH rear brake caliper bleeder screw. Attach a rubber drain tube to the RH rear brake caliper bleeder screw, and submerge the free end of the tube in a container partially filled with clean brake fluid.
4. Open the valve on the bleeder tank.
5. Loosen the RH rear brake caliper bleeder screw. Leave open until clear, bubble-free brake fluid flows, then tighten the RH rear brake caliper bleeder screw and remove the rubber hose and install the bleeder screw cap.
^ Tighten to 20 Nm (15 ft. lbs.).
6. Continue bleeding the rear of the system, going in order from the LH rear brake caliper bleeder screw to the RH front disc brake caliper bleeder screw ending with the LH front disc brake caliper bleeder screw.
7. Tighten the front brake caliper bleeder screw and remove the hose.
^ Tighten to 13 Nm (10 ft. lbs.).
8. Close the bleeder tank valve. Remove the tank hose from the adapter, and remove the adapter.