Front Door Window Regulator: Service and Repair

DOOR WINDOW REGULATOR AND MOTOR

Removal and Installation

NOTE: The front window motors must be initialized whenever any of the following occurs: the motor is removed from the window regulator, a new motor is installed, a new window regulator is installed, a new window glass is installed, or when carrying out any operation in which grease or lubricants are applied to the window system. A new front window motor is in a proportional up/down mode until initialized.

1. Remove the door window glass.
2. Disconnect the window regulator electrical connector.
3. Remove the 7 nuts and the door window regulator assembly.
- To install, tighten to 12 Nm (9 lb-ft).

4. To install, reverse the removal procedure.